Hello guys, actually our instructor asked us to convert the below steps to passive voice instead of active ..how i can do that Proceed with the following step · Mount the specimen in the X-ray instrument (the lab technician and/or your lab instructor will help with the right procedure). · Start the chiller for cooling the various machine components that heat-up with time · Turn-On the machine and wait until only two lights are showing. The two lights are for READY and ON status. · Observe whether the red light at the top left-hand corner of the machine is ON. This indicates that the X-rays are ready. Otherwise, turn the knob to high voltage in order to accelerate the voltage level and get x-rays ready. · Then, turn-on the PC. · Typical process settings are: voltage = 40 Kv, cathode current = 30mA. All operation of the generator and the diffractometer should be through the computer interface. Use Cu Kα radiation ( λ = 1.542 Aº). · Open the software, XRD-commander. · Click on create JOB under the file menu. · Enter the Sample holder No., Sample ID (name), and raw-file name. · Under parameter file, select a standard setting for copper (the material we are using). This should include the start-diffraction angle, step or increment size and stop-diffraction angle. · Run a 2θ scan from 40° to 100°. · The diffraction pattern will be provided to you. Wait for the scan to be complete. · Get the diffraction pattern and excel file containing the Intensity VS Diffraction angle data.